Static Relay/Contactor
|
Single Phase Solid State Contactor - 7100L
Simple, economic solid state contactor for use with the low temperature coefficient loads.
- Current range: 16-100A at 45°C
- Voltage up to 500V
- Simple installation and maintenance
- Optimized design for reduced size
- Protected against transients
- Fast cycle times give increased heater life
- High reliability with no mechanical contacts
|
|
Single Phase Solid State Relay - 7100S
For use with short wave infrared (SWIR) and low temperature coefficient resistive loads.
- Current range: 16-250A at 45°C
- Voltage up to 500V
- Intelligent half cycle firing
- Suitable for SWIR or resistive loads
- Over-temperature shutdown for 250A fan cooled units
- Thyristor short circuit alarm
- Diagnostic load failure detection
- Digital communications
|
|
Single Phase Solid State Relay - TE10S
These robust, generously rated thyristor units are ideally suited for applications where voltage and current surges can be expected. these units can be used to control SWIR loads (current de-rating required).
- Compact, low cost 240V and 480V SSR
- 16, 25, 40 and 50A rated at 45°C
- AC and DC logic input
- Partial load failure detection
- Simple installation and maintenance
|
|
Three Phase Solid State Relays - 7300S
A range of three phase, three leg solid state contactors for use with short wave infrared (SWIR) and Low Temperature Coefficient resistive loads.
- Current range from 16 to 160 amps at 45°C
- Voltage up 500V
- Inputs: Logic (AC or DC) or Analogue 4-20mA which gives time proportional output
- Suitable for SWIR or resistive loads
- Over-temperature shutdown for fan cooled units (over 100A)
- Thyristor short circuit alarm
- Over-temperature alarm
- Diagnostic load failure detection
|
|
|
